Hoofdafbeelding Waters Acquity UPLC; H-Class + TUV detector

Waters Acquity UPLC; H-Class + TUV detector

Artikelnr: 2037
Nieuw in de verkoop
Snelle respons
Betrouwbaar

Omschrijving

Labrecycling has for sale a 

Waters Acquity UPLC H-Class system 

The ACQUITY UPLC H-Class system combines the speed and performance of UPLC with the ability to run HPLC separations. This combination provides many benefits, including these: 

High-pressure, small-particle chromatography allowing faster, higher-resolution analyses, compared with conventional HPLC 
Low solvent consumption (significantly less than conventional HPLC) 
Flexibility in solvent mixing by using a quaternary solvent manager 
A flow-through-needle sample manager that facilitates the transfer of methods from HPLC to UPLC. 
Pump and sample manager design enhancements, to minimize dispersion and reduce cycle time 
An optional, versatile, column manager, to facilitate method development. 

Source: https://www.waters.com

The Waters ACQUITY UPLC Tunable UV (TUV) Detector is a tunable, dual-wavelength UV/Visible (UV/Vis) detector specifically designed and optimized for the entire line of ACQUITY UPLC systems. The ACQUITY UPLC TUV Detector’s innovative light-guiding flow cell design and High Brightness Lamp are each equipped with Intelligent Chip Technology, allowing for the electronic recording of pertinent component information flow, which is then viewable within the EmpowerTM Software database and available for inclusion in a comprehensive status report. Additionally, the design of the ACQUITY UPLC TUV Detector allows for reduced sensitivity to laboratory environmental fluctuations, such as temperature and humidity changes. The ACQUITY UPLC TUV Detector maintains its low-noise electronics and support for sampling rates up to 80 points/s.

Source: WATERS INSTRUMENT SPECIFICATIONS

Sample Manager-FTN​ (flow trough-Needle)

Injection volume range0.1 to 10.0 µL as standard in 0.1 µL increments
Up to 1000.0 µL with optional extension loops
Accuracy (aspiration) 

±0.2 µL, measured by fluid weight removed from vial with 10.0 µL injections averaged over

20 injections using standard 100µL syringe

Linearity >0.999 (standard needle) caffeine 0.020 mg/mL, ACN/H2O (10:90), isocratic 0.6 mL/min, 0.2 to 10.0 µL, to 70% needle volume
 
Precision<1% RSD 0.2 to 1.9 µL
<0.5% RSD 2.0 to 10.0 µL
Number of sample plates  Any two of the following:
·      96 and 384 microtiter plates
·      48 position 2.00-mL vial plates
·      48 position 0,65mL micro-centrifuge tube plates
·      24 position 1.50-mL micro-centrifuge tube plates
Maximum sample capacity768 in two 384well plates or, 96 in 2 mL vial holders 
Four additional positions for dilution functions
Sample compartment4.0 to 40.0 °C, settable in 0.1°C increments 
Temperature accuracy ± 0.5 °C at sensor
Temperature stability ± 1.0 °C at sensor
Injection needle wash Integral, active, programmable
Minimum sample required 3 µL residual, using total recovery
2-mL vial (zero offset)
Sample carryover<0.004% caffeine (UV)
<0.005% sulphadimethoxine (MS)
Advanced Sample Manager capabilities Auto-dilution, auto-addition, and load-ahead
Primary wetted materials316L stainless steel, gold plated stainless steel, Vespel SCP, PEEK blend, DLC

Quaternary Solvent Manager H-Class​

​The Waters Acquity Quaternary solvent Manager (QSM) is a high-pressure pump that can simultaneously pump four degassed solvents through the Acquity UPLC H-Class system. The pump can deliver gradients in eleven curve shapes (linear, two step, four convex, 4 concave).​

Specificaties

HPLC Detector UV-Vis
Waters HPLC systemen Waters Acquity
Op de hoogte blijven van het laatste nieuws?
Schrijf je dan in voor onze nieuwsbrief!
Blijf op de hoogte en schrijf je in voor onze nieuwsbrief